Posted by Will Herring on August 09, 2009 at 23:19:30 from (173.53.239.102):
In Reply to: Buddy Seat posted by dieselpup on August 07, 2009 at 10:20:35:
I know most of us that grew up with any experience driving tractors (or riding on them) know looking back how dangerous a lot of this stuff was. I have ridden in and driven a John Deere 6400, and I can't imagine the 6430 is much roomier in the cab. Is there actually enough room to cram a buddy seat in there, the seat is so close to the wall of the cab as it is? There's not enough room for two people in the cab anyway.
I can remember learning to drive a tractor when I was younger, sitting on someone's lap or riding on the tool box. However, never at any high rate of speed, and never while any work was being done. More of a "scenic drive" than anything. However, in my late teens/early 20s, I can remember hanging onto tractors in all sorts of ways and speeds that in retrospect would seem stupid or dangerous. All I can say is, if you want to take whomever for a little ride in your tractor, then a buddy seat may definitely be a safer way to go - just make sure it is properly secure, the seatbelt is secure, and that you always close the cab door.
Sadly, I've had several friends (and relatives) killed in tractor rollovers and others with missing body parts (mostly older folk from the corn picker years, granted). You have to pay attention and be extra careful around farm equipment.
This post was edited by Will Herring at 23:21:32 08/09/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
