Posted by RodInNS on September 01, 2009 at 05:27:49 from (216.118.158.123):
In Reply to: can i pull it? posted by ChrisLSD on August 31, 2009 at 19:45:13:
I guess that depends on whether you're talking about 5 12's or 5 20's....
Honestly, in that kind of mess I'd want an 18" or 20" bottom and plow it 10-12" deep. IN that situation you're not going to pull a 5 with that tractor unless you go dreadfullslow and have about 1 ton of cast on the front to hold her down. You can try it, but I doubt it will be very successfull. You might be dropping 1 or 2 bottoms off to get that done. If you hit it hard with roundup and wait until it browns off you've probably got a good shot at it then...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
