Posted by D Slater on September 02, 2009 at 10:15:18 from (71.164.43.209):
In Reply to: Silo filling posted by NY 986 on September 02, 2009 at 07:20:39:
Sure do remember those days. Didn't get out much with cows to milk back then so don't know if it was a local thing or not how it was done. We used 50 es model flat bed trucks to haul with, 16 to 20 foot beds and sideboards. Shute on chopper was turned so trucks run alongside when loading. Steel framed pull back board was in from of bed with 2 winch cables fastened to a 2 inch pipe at rear of bed with ends on it to hook the pull back gear motor. Silage was pulled to rear and into a JD belt driven auger blower. Winch had to be hooked and unhooked every load along with the pull back boards drug back to front. Used 2 JD choppers with engines. Continental and wisconsin, continental got used the most, because the wisconsin used twice the gas and if it died during use it took up a lot of time getting it going agian. Both were hand crank. Due to iregular fields in the valleys here a swath was usualy cut through the middle of fields by hand and put in piles to get started without wasting any corn, then fed into the chopper by hand. Lot of labor back then but didn't have time to think about it. For me I think 67 or 68 was the last silage year.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
