Posted by Janicholson on September 13, 2009 at 17:23:01 from (64.61.212.30):
In Reply to: no oil pressure posted by Scott bartlett on September 13, 2009 at 17:01:11:
Priming is needed. Take the oil pressure gauge fitting out of the block. Use a pump type oil can with straight 40wt oil in it (helps prime). Make a rubber gasket to seal the oil pump tip into the threads, from a piece of small diameter hose. Pump until the system is filled. It could take 5 cans if the oil filter is not precharged. When primed, it will get much harder to pump. Put the gauge line back in and fire it up. It should catch in a few seconds. If the pump is accessible from the outside (cover plate or end cap) remove it and pack the gears with Vaseline and reinstall cover. Doing both is the best. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
