"The "art" of metal finishing goes something like this:
Example: mild steel Coarse grit, medium coarse grit, fine coarse grit, medium grit, fine grit, very fine grit, extremely fine grit, electroplate.
Each one of the steps takes the metal "grain" smoother than the last. If you were to magnify the surface you will see the grain of the metal "standing" up with high grain tops and low grain valley's, something like this, ^^^^^^^^, looking at a end view.
By finishing that surface we smooth that grain down to where the grain tops get closer to the grain valley with the above polishing compounds. The finest we can finish that surface grain structure is electroplating.
Electroplating is taking dissolved metal particles and applying it to "fill" in the grain structure to almost a mirror finish. I say almost because if you magnify a electroplated surface you will still see grain highs and lows.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
