Posted by NY 986 on October 06, 2009 at 06:20:00 from (166.217.238.11):
In Reply to: What happens to Silage posted by ryanwheelock on October 06, 2009 at 05:32:46:
Fermentation process happens converting the sugars to other compounds. I'll let the guys with bunker/pit experience address the moisture needed but the upright silos want in the neighborhood of 30 to 35 percent. For fermentation and minimal molding the material needs to be deprived of oxygen as much as possible. With uprights this is a minimal problem but pit silo you need to cover with plastic (after you have packed the material) and use something such as old tires to hold the plastic in place. Corn in the field needs to have the black layer on the kernel with some dent but moist after that. If you cut a stalk 12 inches from the ground you should be able to squeeze juice out but it should not readily run out without squeezing. Overall plant appearance should be green with some yellow at the fringe of the leaves and ear. Plant material should be dry (not harvested in the rain) because the excess water will trap nitrate gasses inside the silage, spoiling the material. However, if you think the material is too dry, you can deliver water at a rate of 5 gal/ min via garden hose into the blower. The pit/bunker guys will have to advise you about adding water in that situation. My preference would be to use a upright silo if available or find someone to bag it for you
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
