Posted by Fixerupper on October 23, 2009 at 07:00:03 from (207.177.13.178):
In Reply to: 52 A posted by Coach Ag. on October 22, 2009 at 16:30:10:
If you can weld a nut on it, after the nut is welded and has cooled a bit, put the wrench on the nut and lightly twist on the nut back-and-forth just a little bit and gradually twist with a little more pressure as you are twisting back-and-forth. Sometimes I use a vise grip instead of a wrench because the vise grip is absolutely tight on the nut and I have a better feel for whether the stud is coming loose or not. Sometimes the stud turns right out and sometimes it turns a little and stops. You just have to take your time and not get too anxious about it. If you just put the wrench or vise grip on it and start turning it like you would a normal bolt you might twist off the stud again, only it'll be deeper in the casting and harder to get a weld on the next time.BTDT.
If you have to drill it, drill a small hole directly in the center first, but don't drill clear through the bolt and into the water jacket. Then try a left hand bit that's bigger than the first bit. The left hand bit will grab the bolt better if it's merely enlarging the first hole. Good luck and take your time. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
