Well I said I wasn't going to comment anymore on this topic unless I was asked a question but to clear matters up this land is rural property out in the country, no subdivision. My parents have plat maps of property that they received 40+ years ago, these are plats that are registered at the county courthouse, they also have the deeds with all discriptions, footages, etc of said property, both previous land surveys were done by different companies about 15 years apart and corners of property were marked at exact locations each time. We know where the markers should be. I don't want to put permanent markers up until survey is done because I could be off by a 3-5' area, there will be no miss understanding with adjacent property owner after this legal/licensed survey is completed because he will get the message! It will be photographed, marked with railroad iron, painted, and fenced off, and GPS with gov't issue equipment. As far as the outcome of this I'll re-post this topic later on if anyone wants to know how it turns out. Also this troublesome neighbors property was surveyed by the same contractors at one time when my parents had a previous survey done, so he dang well knows or should know where the corners are. Mom said he wants to buy property should they ever sell it, no way in heck for him to get it if I have any say!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
