Posted by TonyIN on October 31, 2009 at 08:05:14 from (72.49.225.36):
In Reply to: OT: lightweight roof posted by Dan-IA on October 31, 2009 at 06:45:10:
Not sure if I understood correctly, but it sounds like you're using conventional 2x4 wall framing with plywood over the 2x's for the walls? If so, even with the 2x4's at 24" o.c. you've basically got typical house framing for the walls. That should support most roof systems just fine. Now for the rafters... if you're going 16 ft, 2x8s would be about the minimum or it will sag over time. 2x4's have a hard time supporting their own weight over that span. Not only that, but the quality of lumber for 16 ft lengths isn't that great until you get into 2x8's. 2x8's are also usually a better grade of lumber - i.e. a structural grade. Keep your rafters at 24" o.c., lined up with the studs below, and 1/2" plywood sheathing is fine - be just like your house roof. Possibly a cheaper route if you can find it is some old insulated panels - usually 2 to 3" thick rigid foam with a thin plywood or other type board on each side. span these at 4' o.c. (but don't walk on them) and it should hold. 24" o.c. is better. Some items to consider: Most of your heat loss will be through the roof in any design. The steeper the roof slope, the less snow load/weight. Ultra cheap/ugly route? Check with a local signage shop - they usually have old 4x8 plywood signs laying around. Lumber yards also have 4x8 sheets they couldn't sell for various reasons that they will sell very cheap. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.