With all due respect to TBone's experience, I have to dispute two points:
1) 500 FPM in a metal branch duct is NOT excessively noisy. A very typical room application might be 100 CFM through a 6 inch metal duct, giving a flow velocity of 533 fpm. I live with such a system every day and it is fine from a noise perspective (very conservative actually).
The typical "ductolator" allows 700 fpm and up through the ducts. 500 FPM at return grilles and registers MAY be excessively noisy, which is why they are sized to a lower flow velocity. But 500 fpm in a DUCT is fine.
2) Excessive friction loss in a duct system will NOT "cause the fan motor too (sic) fail because of too high of static pressure". An ordinary centrifugal fan or pump draws LESS power, not more, as flow resistance rises. There are many reasons to be concerned about excessive flow resistance, such as heat exchanger temperature, duct temperature, and overall SYSTEM efficiency, but failure of the fan motor due to too high of a flow resistance is not one of them (variable speed drives excepted). Look at any text on "fan curve" or "pump curve". Here is a quote from one of them:
"As the static pressure imposed on a blower driven by a PSC motor increases, the airflow decreases, following along a pressure-flow line on a fan curve. Because the power consumed by a fan is proportional to the cube of the airflow, power consumption also decreases with increasing static pressure when PSC motors are used."
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.