Posted by NE IA on November 05, 2009 at 05:20:36 from (206.72.18.153):
In Reply to: Concrete slabs posted by J. Schwiebert on November 04, 2009 at 18:33:29:
Fiber is a secondary reinforcment, not to be confused with the most important reinforcment -rebar.
A uniform subgrade is probably the most important thing required for a good job.
If half the slab is a cut, and the other half is fill, it will crack 99% of the time in frost areas.
Since 1964 I have never poured less than a 4,000 # mix.
I would consider 6" if you can afford it, 4 is ok but this is simething you intend on doing once.
Spend a few dollars and put chairs under the rebar so they are in place--lower 1/3 of slab.
I argue these issues on a weekly basis, my coment is always --just drive around town and look for yourself, then come back and we will discus the issue.
I am lucky to work for 99% of the folks that want it to be perfect in the end, not just get by.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
