What if I have the deed and it specifically says so many feet to the pipe driven in the ground which is in the fence, would I still need a survey as there would obviously have already been one when these several parcels were plotted off the main parcel? Costs about $2000 to have a competent surveyer do the work, I know as we have had several surveys in the last 5 years. I was hoping maybe I could send them a letter something like, you have 30 days to remove building(s) from our property if you do not respond within 15 days you recognize and acknowledge you have built on our property and will either remove within the 30 or we will remove at your expense. If you do not know where the line is you must respond within the 15 days and must have a survey done to prove the line.
That way they shell out the money for the survey or they move the building(s) and hopefully both. Like I said there is a metal pipe in the fence running along the property side between us which is about 5 feet from the back fence placing the line between the fence and their property and the neighbor on the other side that owns that lot just found the pins at both his corners which are the same footage from the fence in our favor and he agrees that those pins are the actual line. Common sense says the line is 5 foot from the fence but I ain't dumb and know common sense and lawyering are two different things. Thanks for any and all useless advice you can give!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
