The code now requires that you run a ground conductor from the service to each sub panel. Grounding and bonding at each sub panel is no longer permitted. Your ground rods and bonding with the neutral should only be done at the main service which sounds like it will be in the shop. It is very important that all the sub panels have the neutrals and grounds seperated on different terminal bars and that they NOT be interconnected or bonded. If you are reusing existing equipment in the other buildings they may have to be rewired to make sure this is done. Not a big job but a big deal. The size of the ground conductor will be based on the size of the breaker feeding each panel.(Table 250.122 in the NEC) You can find information about all this in Article 250 of the NEC. I would encourage you to upsize the conductor for the ground. Also, if your runs to the other buildings are very long you may want to calculate voltage drop and consider upsizing those as well.
It sounds like you are aware of the importance of grounding. Bonding is a little more complicated. You may want to have a licensed electrician take a look at your job when it is done.
Also, you can find a lot of information on grounding agricultural buildings on the internet. Stray voltages seem to bother cattle and horses more than other stock and some of the soloutions need to be done during construction such as grounding mats in concrete and such. Attention to grounding what is there will likely solve most of your problems.
I got called to a farm one time for a service call. The guys hogs were dying for no apparent reason. Turned out that improper grounding and bonding (along with an underground splice made in a coffee can filled with tar)had electrified all of the metal siding on his barn and when the hogs bushed against it with their feet grounded in the wet dirt they were freezer bound. Lucky it wasn"t him.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.