Tractor Talk Discussion Board |
Re: Re: Any one ever Built a Home made rock picker???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Canadian Cowboy on February 06, 2001 at 19:37:02 from (64.114.14.21):
In Reply to: Re: Any one ever Built a Home made rock picker??? posted by taylor lambert on February 06, 2001 at 17:45:52:
I like the idea's, I had one today too, Id like to share it with u all, might be a little off the wall and won't work, But a mechanical way of picking rocks beats trying to hire people or friends to pick rocks, I was thinking of getting a heavy truck axle 1ton to 3 ton, taking narrow gauge rail road track an cutting it into 3 foot lenghts. On top of the axle would site a square frame, welded to the axle sort of like a trailer frame only the frame would start right on top of the axle instead of the middle. The track would be welded onto the frame and pointing into the ground at an angle like a pitch fork, a shallow angle. I would have to rig up some sort of hitch on the out side of the frame going around the train track to a point where it could have a hitch for a tractor to hook onto. I would drag this unit in the ground behind the cat or tractor, hopfuly the rocks would traval up up the tracks to the top of and fall back into an old ore car bucket I got from an old gold mine. The bucket is perfet because it hinges in the middle, If I plan it right i can have the ore bucket leaning over a little to let the rocks fall in easier then when it full I could use hydrolics to tilt the bucket back and dump the rocks out the back. Its realy crude, id have to have some realy strong steel to with stand the load of the rocks and being dragged in the ground, I wonder if there is some way of utilizing the rear end of a truck frame, how do i make the rocks go up hill?? just some thoughts what do u think?
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|