Posted by jdemaris on December 19, 2009 at 07:13:08 from (67.142.130.32):
In Reply to: 1020 Deere ignition posted by rrlund on December 19, 2009 at 07:02:16:
No, nothing special about the igntion system.
Sounds like you've either got a bad IGN pole on the key switch, or a bad carbon resistor wire to the coil primary postitive terminal.
1010 is a bit special, but not on the 1020. It uses a carbon resistor wire (like GM cars) to limit voltage to the coil while in "run" position, so maybe you've got a resistor wire problem? Check voltage to the coil primary when running. If it's not 6-8 volts at least, it's time to replace or bypass the wire or replace the switch (or bad connections). A cheap porcelain 1.8 ohm resistor from NAPA will work fine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
