Tractor Talk Discussion Board |
Re: Diesel Starting With Starting Spray,Good Or Bad?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G Taylor on February 11, 2001 at 19:11:19 from (64.10.111.224):
In Reply to: Diesel Starting With Starting Spray,Good Or Bad? posted by TMAC on February 11, 2001 at 18:58:52:
Ether is a powerful solvent that washes lube oil off the cylinder walls. If nothing else ring seal will deteriate with the rings & cylinders scuffing. There are the exotic failures caused by ether detonation such as broken rings/piston ring lands, pounded rod bearings etc. How many RPM does an accurate tach indicate starting RPM to be. A diesel relies on the universal gas law to operate. Squeeze the air enough & fast enough before the heat is absorbed by the surounding metal. Piston to cylinder wall seal leakage has to be low, valves perfect,cranking rpm fast enough & injectors spraying instead of dribbling. Even if perfect very few diesels will start without preheating or glow plugs below freezing temps.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|