Posted by Fixerupper on January 03, 2010 at 12:31:46 from (207.177.13.178):
In Reply to: Allis 8070 posted by muckfarmer on January 03, 2010 at 06:42:33:
Well, no one else has replied yet, so I'll give you what little I do Know. It probably has the 426 cu. engine. They throw rods. More than the other brands. I've seen more than one or two with a hole in the block sitting in the dealer's shop. The Allis mechanics around here tell the owners to replace the rod and main bearings every 3000 hours, change the oil religiously and everything will be fine. My neighbor has a well maintained 8000 hour 7060 with this engine and he's never had an engine problem, but he's had the bearings changed twice just as a part of his maintenance program. One mechanic's version of the cause of the problem is the block spreads lengthways so oil pressure is released out of the front and rear mains. That's the only major chronic problem that I know about. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
