Posted by Pycoed on January 04, 2010 at 15:49:35 from (86.155.3.111):
In Reply to: How to Pull a Hub? posted by buickanddeere on January 04, 2010 at 13:33:28:
1 Dollar said: (quoted from post at 23:33:28 01/04/10) I'm working on pulling a 12 spline hub off of an Unstyled A, and it is having no part of it. I've bent my 3/4 inch puller so now I'm looking for some pointers.
Looks to me as if the hub you are pulling is pinching the collets onto the splines, so it doesn't look as if its designed to come off that way. I'd clean off all the rust & soak in releasing oil, then try driving the outer hub inwards with a piece of heavy pipe that fits over the collets & a sledge. If I see this right , that should then pop off those collets which can be removed, then the hub. It seems to me to be like a giant valve stem/cap/collet arrangement (with splines).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
