Posted by TonyIN on January 04, 2010 at 18:32:53 from (72.49.225.36):
In Reply to: O/T Will It Work? posted by Allan In NE on January 04, 2010 at 15:13:16:
Looks like someone was putting the "whammy" in whammy bar. That"s some impressive work there.
I would have to agree with Tom as well... that metal to wood connection on those was a tight fit friction deal and I doubt with the stresses a tremolo presents that you will get a long term solution otherwise.
Being a recovering tone addict myself, I would be highly tempted to go the wood block path. Then it could potentially make things better if the wood block you rout in is of another species - i.e. one to increase sustain or warm things up a bit. may also be worth dovetailing or fingering in the new species for better transfer of the wood"s tone...
Good luck and if you don"t mind, drop me an email with the solution that works out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
