onefarmer said: (quoted from post at 14:37:32 01/18/10) I was and still am agreeing with you. If everything is correct, big leads to their terminals and center tap 12v chassis grounded. All good. Something goes wrong then the smoke is let out.
"Something goes wrong then the smoke is let out." Isn't that always the case with anything electrical?
On another point, however, we likely have a bone to pick. I see nothing to suggest that the following is an accurate description:
The generator is a split 24v also. The 24v splits into 12+ and 12- with a center chassis ground. So each batt gets its own 12v and gets charged individually. This balances the batts so one doesn't cook while the other is still under charged.
I believe that the charging is a simple matter of batteries being charged by a single, non-split, 24volt gen/reg where the current is the same thru the series of batteries, with no provision to yield any more or any less charging to one battery than the other, even if one should be more discharged than the other. That generator is just like the starter in that it knows of no ground and that regulator only knows of 24 volts and knows of no ground and thus knows of no +12 and -12.
I could be wrong, but so far see no evidence to support that position.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
