...uh, don't do much with guns anymore (I hate cold weather and prefer to fish off of my boat in warm weather). However, 30 years ago I worked in a gun store and owned a .270 rifle. Mixing calibers in any gun, especially high-powered rifles, would be in my humble opinion both very stupid and very dangerous. A bullet has to fit snug to the bore of the barrel as it spins during the travel out of the gun. It is the seal of this fit that forms the barrier for the compression of the powder fire. If memory serves I used to shoot 110 and 130 grain loads from my .270 and fire would shoot out of the end of the barrel five or six inches when using the 130. It was pretty hot - I bought the .270 as a "hot-rod" kid because the kill power was slightly better than a 30-06 and it was a popular caliber with bear hunters in the 70s. I thought it was "cool" at the time, but I could barely afford to shoot the stupid thing and I never went bear hunting with it or any other gun. I had enough bad luck shooting a cousin's shotgun reloads on trap (an he was a pretty good reloader) that I don't think I would consider shooting an amature reloaded anything in a .270, 30-06, .357, etc, etc. (anything with a bore and some power).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
