Posted by George Marsh on February 17, 2010 at 13:52:09 from (71.114.168.155):
After discovering that condensation inside my hydraulics was causing my control lever to freeze in position and screwing up the hydraulics on a Jubilee, I decided that doing nothing was not an option. Parked tractor inside heated garage and left the hydraulic fill cap off for a few days. Applied heat with hair dryer. Even loosened the drain plug and found no water in the oil. Sprayed hydraulic fluid on the control levers, cam and springs inside the case to displace any moisture and will continue to do so as part of a PM plan. I decided to cut a 3 inch strip of Sham Wow, the length of a sock. Put the Sham wow inside the sock and rolled the sock up. Then put the sock in the fill hole. Tight fit, no worry of it falling in. My thinking is that the sock will act like a wick and transfer any moisture trapped inside the hyd case to the outside. When conditions are warm enough the sock will dry. Does anyone see how the sock can hurt anything? Wicks have been used in oil lamps and even seen brick layers put wicks in the bottom row of bricks to remove moisture trapped behind the brick. If this works I might be looking for another fill cap to design the next generation of wick to remove moisture. Just brain storming here. Hope I don't get poofed, so make your comments PC. I've never used a tampon before, but been thinking that it may have better moisture absorbing ability than a sham wow and a sock. I can't see myself going to Wal-mart and asking if they make an industrial size tampon. May need to send a female friend to find out. I'll drill a hole in the top of a second fill cap and put half of the tampon inside the case and the other half exposed to the outside air. BTY, does anyone have a better idea for a wick? Will keep you posted as to the effectiveness of the sham wow and sock or if I decide to send a friend to Wal-mart.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.