I'd probably agree with the cutting silage; it was my dad's operation and we used a 4020 and a 2-row A-C cutter (a 760 or a 780, I dis-remember). It was a cut-and-throw machine and the 'moan' it made could be heard all through the community. The silage went into a trench silo (the pit) and the trailers weren't that big, about 7 x 14 x 4 1/2 ft tall. If everything was working right, we cut as many as 8 loads per hour. Had a man to ride the back of the machine/front of the trailers. I'd motion, he'd pull the pin, I'd drive forward a few feet while adjusting the the chute to keep the silage in the trailer, I'd stop and the fellow hauling would whip the next trailer in behind the cutter. The guy doing the hitching/unhitching would pull the pin; tractor would pull out of the way and I'd back in for him to hitch up the empty trailer. Fellow hauling would do his own hitching up. Depending on how far the field was from the pit, there would be 1, 2, or 3 'haulers'. Trailers had false front endgates to pull the silage out at the pit; 2 or 3 guys at the pit, 1 tractor driver to pull the silage out and 'pack' and the other to hook onto the false endgate and put it back into the trailer after it was unloaded. The dust in the field roads would be as fine as flour and 6 inches deep. A load every 7 1/2 or 8 minutes; I loved it. We did a lot of custom cutting within the county and filled 10 or 12 pits or silos each year. New highway got our pit about 25 or 30 years ago and we went to an all-hay operation, instead of silage.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
