Posted by Dan in North Houston on March 09, 2010 at 17:23:45 from (69.7.123.172):
In Reply to: f-150 oil change posted by Toby Oats on March 09, 2010 at 15:14:31:
for my '01 F150, I have an oil filter wrench that is like a big socket that fits over the flutes on the end of the filter. It accepts a 3/8" drive ratchet. I also have a specially cut stick about 18" long, about 1" x 1" cross section. I place the wrench on the end of the filter and use the stick and a hammer to tap the wrench on snug - you can't get it tight enough by hand. It's a lot easier with the left front tire removed but it can be done with the tire on. Once the wrench is snug I can use a flex head ratchet to loosen the filter. to install the filter, just reverse the process. I have found that you can't get the filter in past the tie rod with the wrench on the end, so you have to tap the wrench on with the stick and hammer again. After tightening, a tap from below with the stick will pop the wrench off.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
