Tractor Talk Discussion Board |
Re: need value on JD 4020
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JD70Jim on May 10, 2001 at 10:07:12 from (64.197.39.79):
In Reply to: need value on JD 4020 posted by David M. Huey on May 09, 2001 at 14:55:21:
Without knowing more about the tractor, such as: is it powershift or syncro range? How many SCVs? Is it gas or diesel, wide front or narrow, what size rear rubber and condition, does it have 3 pooint that is complete and operable, and most important, where is it ? Not knowing these things makes it hard to say! However,I saw a 1963 JD 3010D at a local consignment auction go, about two years ago or so. It was a sorry tractor. The engine was stuck and full of black goo. The injector pump was partly dissasembled, The muffler had largish holes in it and the shwartz wfe had three welds on it. It had dual SCVs, both corroded to junk and the levers didn't move. The steering wheel spun freely without any resistance at all. The brakes were frozen and the pedal wouldn't move. The clutch pedal wouldn't move. The gauges were all shot. The seat was rust and rags. No top link or pto shields. The radiator held rusty red stuff but had no radiator cap. The generator and starter appeared to be "poor". The sheet metal had holes. The fenders were bent and lights were gone. It had a real nice NEW set of 15.5x38 Goodyears. It brought $2500.00 Go figure! Your Father in Law's tractor COULD be worth anywhere from $4000-8000, depending a lot on the sruff I mentioned in my first paragraph.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|