If a plug wire end or screwdriver etc out a cap terminal is placed within about 3/16 from steel you should see a good visible blue spark and thats the goal, NOT a faint thin wimpy yellow spark.
Soooooooo if you can get such using a wire or screwdriver etc out the cap BUT theres no spark with a good plug attached and well grounded, sounds like EITHER the plug wire or plug may be bad.
See if you get a good visible blue spark if you hold the plug wire end to within 3/16 of steel??? if so but theres no spark using a well grounded plug, the plug must be bad. Try swapping different wires and plugs to isolate if its a plug or wire problem.
Since you replaced points and condensor Id wonder if the new condensor is good and/or the points are gapped proper and theres no shorts in the points or points and condensor wiring. Try it with the old condensor n see what happens
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
