doug in illinois, I run a 966 with a loader, IMO you can use pickup tires to do the job you are asking. But I will throw in my $ .02 here! Why? when there is the Airplane tire opition. My first set went 10 years and were roaded a lot. 20ply tires will last a lot longer than pickup tires. Gensco @ Houston Texas is one place to get them from. I used my OEM Ag rims on the first set, My current set is 3 yrs old I bought a New set of HD center wheels to mount them on. Not from Gensco! I run my with tubes, (personal prefference) Though I have seen some that were cut uneven and would ruin a tube in no time. Tell them to make sure they get thm smoothed out if you do intend to use tubes. Also If you are going tubeless! Get a newer carcassed tire for I have seen one tire that the side wall gave way for the tire was older and dry roted It was filled with sealer but it just always stayed wet with sealer for the time it served just agravating to have to replace in a shot time. About 1 yr. They will want to sell you their wheel and tire combos but,,,,,Measure your wheel back space to ensure you do not get a wheel where the tire ribs on the front end assembly on your tractor and cause premature tire failure. Our use your OEM wheel. As other have said Check the toe in on your tractor to make sure yours is right! If you need more help Hollar @ me My #...512-577-3837. Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
