Lanse I can only tell you from my own experience. I did darn near the same thing and it worked out great. Back 15 years ago we had a barn full of milk cows and once a year we were required to have the barn whitewashed. This meant about 2 days before the whitewash guy showed up we would take air nozels and blow as much dust and chaff and what ever else out of the barn so it could be painted. I had a tank from an 80 gallon water heater that I mounted to an old 2 wheel trailer and had picked up a V4 freon compressor which got plumbed to the tank. I then mounted a PTO shaft to the pump and used a tractor setting outside the barn running the pump, to be able to clean the barn. It pumped enough air to be able to run 2 hoses almost nonstop. I plumbed a pop off valve from a water heater into the tank and used this for when we stopped using the hoses. The tank would build up pressure and about 125 or 150 PSI, the popoff would blow and the tank would not over pressurize. I used this setup for at least 3 years before the whitewash appointment and it still sets in the pasture fence row up home. By all means be careful but yes the idea is very feasible.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
