Posted by GUIDO on May 23, 2010 at 13:59:05 from (96.235.128.172):
In Reply to: Air intake question posted by Ron Corkum on May 23, 2010 at 12:43:41:
Hello Ron Corkum, Start the engine from cold(OVERNIGHT) or at least 4 hrs after shut down.Then check the heat on the exhaust on each cylinder. If you do not have a temperature gauge, check with your fingers. Just touch each one for a second or so, and compare the heat. At this time the ports should not be really hot enough to burn you. Be careful just the same. You can also try a bit of white lube on each exhaust port, and observe how they melt. If a cylinder is not firing at all the grease will not melt.If its weak it will be last one to melt if at all. Good Luck...................Guido.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
