With baler not hooked to tractor, support the pto shaft so it will turn (and not kink) as you turn the flywheel by hand- make sure the plunger "plunges" and pickup turns like they're supposed to.
Then get someone else to turn the flywheel while you trip the knotter bar (at the star wheel on top of the bale chamber) in the rear. Watch the needles as they go through the knotting cycle (no twine or hay in the thing yet, of course)- the eyes of the needles should be very near the bill hook at their furthest upward travel, then go back down to resting position, without the plunger hitting them. Meanwhile, the billhooks should be going through their normal gymnastics. It will be harder to turn the flywheel during the knotting cycle, but not extremely so. If you come up to a "stop" condition in the turning of the flywheel, nudge it a little, back and forth, but don't force it- try to figure out what's froze up and free it rather than break it.
If everything is good so far, hook it up to a tractor and engage the PTO slowly, at idle. Let it run a bit, to get the grease spread around. If all is still well, load with twine, and feed it hay until it goes through a tying cycle. If it won't tie correctly, wait for the manual you ordered to arrive, and start going through it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
