It's not as bad this morning so I'm going out the door to start working again. Not being in searing burning pain puts a person in a much better mood. Been laying around for a week doing nothing so this will be the test. I'm not a lay around and do nothing person by any means. This methylpredsilonoe he put me on is a one week regimen where I take six 4mg pills the first day, five the next and so on until I'm down to one on the last day. They are about as bitter tasting as anyting can be! I still have a minor stabbing pain above the left hip but it's nothing to "whine" about.
Oh yes, to make this tractor ralated, I'm going to be scooping dirt with the loader on the 630 Deere, dumping it in an old Heider 6X10 wagon with single 2X12 side boards and a steel floor on a Case 3 ton running gear with a midwest hoist pulled by the old SC Case. There! Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
