Posted by dave2 on July 19, 2010 at 10:38:44 from (139.139.35.70):
redone a room over the last 3 or 4 months. Involved relocating water lines, heating pipes and adding floor heating and a radiator. Fixing a crooked wall by framing and using drywall and used the oportunity to hide some wiring (electric main was running up thewall to the box) and heater pipes to the adjoining room. Everything finished yesterday with new floor tile and tile on the walls. Turned on the heater to check for leaks at the new radiator and a couple other places before putting the access panel in place. walked into the room and all was well except an awful noise in the wall. Shut everything down, felt sorry for myself a little while, and got the hammer & chisel. took out 2 tiles and cut the drywall. Guy hanging the tile fastened a 2x2 so he could start the tiles straight. Ran a screw in the wall and dead center in a 15mm copper elbow for the heater in the next room. quarter inch left, right, or up and all woulda been well.
All good now thanks to a little headscratching, PEX tubing/fittings and a sharkbite fitting. Get to patch the hole tomorrow.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
