Posted by Adirondack case guy on July 27, 2010 at 19:15:49 from (67.252.92.228):
In Reply to: 931 case pto shaft posted by gene pesch on July 27, 2010 at 18:47:57:
If this is a CK with DOM 3pt. It's pretty easy. Remove drawbar- remove bolts suporting drawbar support bracket and let it swing down. Drain trans. 17 gal. Disconnect pto lever from splined shaft, remove all bolts from housing and pull it away. Broken shaft does not allow you to put a peice of pipe over it to balance the housing so removing it may be aukward and the hyd pickup screen could be damiged if not carful.Once the PTO housing is removed you need to remove the inner casting suporting the front of the PTO gear train and replace the shaft. A 4hr. job for an experienced tech.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
