BCnT is correct and your complaint is common. The Ford transmission is too fast in low gear to handle a rear mounted roto-tiller or a rear mounted snowblower for that matter. Addition of a Sherman step down won't help either. The PTO is "ground driven" and will turn slower. I've often wondered if the tiller would be able to propel the tractor forward (assuming the tines rotate in that direction) on level ground if set at the correct depth with the tractor in nuetral. If it propelled the tractor too fast you could either raise the tiller or use the brakes to slow it down. Probably not in all situations. On hills, forget it. But it might be worth a try before you run off and buy a new tractor. One roto tiller that will work is a Howard 3 point roto-tiller from Australia (I believe) which provides gearing to accomodate the farm tractor speeds. I'm told they're hard to find and $$$$$.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
