OK, So I am excited now that I might be able to drive over to Dad's and put a chain to his 46 or 37 G. No bore, and I think ~ 38-40 horsepower.
Good grief, now the juices are flowing. Is 50 HP within easy range, or, are stepping into money and more radical upgrades (kindof makes me think that at some point, you have to consider the crank and rods durability)
So, this is what I just digested from your comments, and a few more questions if You don't mind.
1. High Compression pistons and gas manifold.
Question: Going higher compression, leads me to think that I will likely be advancing timing. If I remember correctly, timing on the ol g is 25 deg BTDC. If this is true, can I do it by ear or to truely dial it in do I have to find a dyno somewhere?
2. Distributor: It has a mag on it. Is the switchover easy (bolt up) to current governer body, add coil, etc? Is this a common upgrade?
3. Water pump: Our ol G's were notorious for overheating (even on Tractor fuel!), no real surprise here. Is this also a common upgrade wherein I can find an upgrade kit and simply bolt on the pump, add the pulley, and modify the cold water return? I just tried to find this kit, and I must be lame in my searching.
4. Are these types of upgrades the types of things You would do even if You were not going for much more horsepower, but just to take advantage of current fuel, technology?
I plan to keep this tractor in the family from here on out. Want to stay close to originality, but not completely married to it. I want to have fun and work it a bit (work on these = fun from me).
Thanks again, to all of You for your comments, in advance.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.