After convincing my wife that she should learn to use the "new" (1977 Ford 3600) tractor for brush hogging, I told her to just cut the wide open meadow I had cut a couple of weeks earlier to get used to it. As I watched from a distance she headed off into the 4 ft tall stuff at the edge that I had left uncut because of the fallen trees I had cut up a while back and hadn't cleaned up yet. Now you could see the big pieces laying all around (if you were looking where you were going :wink: ) but she just headed off into it. Kept on going even with the tractor bouncing over the wood, brush hog making a terrible clatter. I grit my teeth and didn't say a word as I knew if I did open my mouth, it would ruin BOTH of our days.
Later that day, she was helping me unload broken concrete (BIG pieces) from the pickup to use as rip-rap around a culvert. I was standing in the ditch to place them and told her to just drop them over the side of the bed. Well she TOSSED THEM and they proceeded to roll down the bank. As I dodged a couple of 20-30 pounders, I just said, "Whoa, let me get out of the ditch". I then showed her how to do it. I find that I'm mellowing in my old age and trying to be more tolerant of those who may not know how to do something the way I want. I figure if I didn't explain it right, I can't complain.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
