Posted by CB in central NY on August 16, 2010 at 13:31:27 from (216.81.94.73):
This is quite O.T., so I apologize in advance.
I am in the process of constructing a chute to bring firewood into the cellar (only access point from outside, no bay doors). In order to do that, I need to break through a brick wall three bricks deep. I also need to do it neatly so that I can square it off and insert a small framed door. I have tried a hammer and chisel, slegde hammer, LARGE crow bar, etc. All I get is small chips (feels like breaking out of prison). The only thing that is somewhat promising is a air chisel (but my compressor is too small).
Any ideas on how to make a neat square opening 21"x15" would be greatly appreciated. Thanks in advance.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
