John is a special person that has had a lot of varied experience. He and I have always had a difference of opinion about who should attempt to rebuild/patch up a Roosa Master pump. Guess that is the perfectionist coming out of me. I have always been one that has to do it exactly right, but that is just who I am. If you are looking for perfection or have a pump that needs more than just a reseal, it needs to go to someone who has had years of experience after having factory training like John and I have had. And even then, it can be a challenge. Only the most experienced can tell by looking if a part should or should not be replaced for for a long service life. Even simple things like the transfer pump blade springs or delivery valves can be ready to fail or knowing how to check for the presence of water having gone through the pump.
I remember a CB pump that came through the diesel room that gave me fits back in the 70s. It simply would not settle down on the tractor, nor would it on the test stand. The first thing I checked was the air seperator for blockage. To make a long story short, there was a shiny sliver of steel in the bleed hole that made it appear the hole was empty. Only found it when I tried to to run a pin punch through it.
Not saying you can't do it, for I,too, have torn apart pumps on the tailage of a pickup truck,even in corn fields. The most memorable was a brand new 4320 at the Indiana State Fair. The dealer I worked for wanted to use it as a pull back tractor on the tractor pull strip and to also pull it as a demonstration. First 4320 I had ever seen as it had just been released from Deere that day, I pulled it apart, removed the shims and set the pump wide open. Talk about a new model making a show,it did.lol. Good luck and go for it. You won't learn Any younger. bob
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
