Posted by Farmallb on September 29, 2010 at 10:11:18 from (12.74.230.47):
Ive thought about useing an old manure spreader frame, and makeing a front wheel drive looking tractor like the AC 6-12, Hoke, Moline Universal, Square turn, ect. I had thought of useing a small car/pk engine, trans, 4 cyl standard, cut the drive shaft down to nothing and mounting it on the spreader frame. I would like to use the bull gear on the spreader wheel and chain, for the looks. I would have to find a way of attaching a like gear on the R side of the rear end, and a pulley wheel on the left. My question is, How would I utalize the pulley wheel without the tractor moveing. I know that in the old days many farmers bought a pulley wheel, mounted it on their car and jacked the wheel up and ran a belt off of it without the car moveing. I dont know if that would be possible with modern rear ends. Also, Im not sure the axle would hold the weight of the engine, trans and rear end, and still pull say one or 2 David Bradley walking garden plows, or 2 DB discs, or a section harrow.
If it wouldnt hold the weight, Then, if I used a side shaft 14hp engine, how could I get the power from the shaft to the drive wheel, and utalize a pulley wheel
Id like to make this, and take it to steam and tractor shows, just to ride around on. My ankles are shot, and I cannot walk the distance of seeing these shows anymore.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
