Posted by Allan In NE on October 10, 2010 at 05:54:28 from (148.66.88.254):
In Reply to: IH 1600 grain truck posted by GeneMO on October 10, 2010 at 05:10:45:
The carb throttle/governor assembly works exactly 'backwards' from the way you'd think.
The way that thing works is that spring pressure always tries to pull the throttle plate wide open.
Then, when cranking and/or running, engine vacuum (via carb internal passage) then forces 'er back towards the closed position and the idle stop by the use of the governor vacuum diaphram.
Has someone just worked on this carb or had the carb off?
Is the diaphram hooked up, is it leaking or is the linkage on correctly? How about the two carb throttle return springs (one inside the other)?
The little spring/linkage inside the "box" on the side of the carb okay and installed correctly? Has the diaphram arm to the throttle shaft on the shaft link come off?
Is that little "arm" on the end of the throttle shaft pointed in the right direction? If on backwards, the diaphram will assist the springs to "open" the throttle shaft.
I'm going by memory here, but hope I've kinda led you in the right direction.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
