Posted by Rick Kr on October 10, 2010 at 20:23:56 from (67.108.90.72):
From the last post: I was running TSC 85w140 in a new 6 ft tiller and the oil had foamed.
Lots of people said just run it, its fine, others said get a better oil, TSC is cheap oil, some said synthetic.
I pulled all the oil out the gear box with a vacuum pump. Only the top 1/2 inch was foamed/bubbles. The rest of the oil looked fine. The side case, I pulled the drain plug and the oil came out good too. So I didn"t drain all of the side case.
I filled the gear box with new valvoline, and had to top off the side case with 12 oz. of valvoline. I then went out and tilled 3 acres at 540rpm on the PTO. A full 4 hours of running.
The results: Absolutely no foam in the gear box or side case. Both cases looked perfect without foam or little bubbles (air entrenchment).
I guess I am wondering does the valvoline and other better oils contain some sort of anti-foaming agents? The side case had 48oz of TSC oil topped off with 12oz of valvoline. Was the 12oz enough to stop the foam? I can"t think of another way to test it, 4 hours straight. I checked the temp of both boxes with my hand, neither was too hot to hold on to (yup, I shut off the PTO).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
