I don't see why it would not work, make sure to disturb,rake or work the soil a bit, so to get good seed contact, ought to fill back in with what you want. Spot patching is good practice in a small field or wherever feasible because those are where weeds or undesirable plants may start to grow. We have a small field, about 7 acres and I have often weeded it by hand, just to keep things from getting out of control. Might do the same as you did, oats will come up with just some soil contact, and adequate water, I've had a whole field come back in a wet summer, from what the combine left behind and what seemed to grow back, if not for the weather it could have been harvested again, much less yield, but surprisingly no weeds.
Same field has be in oats the last 3 years, and last year the oats did not come up as high, I think he omitted fertilizer when they sprayed 2-4D for weeds, so they did not shade out the soil enough and soon after they were ripe, a thick grass like weed took over. Was a hot dry summer too. When oats get too tall, they will eventually lean, and we had to put these guard extensions on the combine grain head, to pick em up, but the straw yield is much better, so is the shading of weeds.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
