Posted by JMS/.MN on October 29, 2010 at 23:04:25 from (209.237.107.155):
In Reply to: figuring field losses posted by J heikemper on October 29, 2010 at 21:24:10:
It"s a bit more complicated than that. Gleaner op manuals, or the little shirt pocket notebook they had years ago, gave a step-by-step procedure to go through, depending on the combine and head. First of all you need to calculate loss in front of the head, (which you cannot save since they already popped out of the pods, usually from being too dry, or swelling after a rain) then between the head and the rear of the machine- that gives you actual header loss...then behind the center of the machine for separator loss, and losses to the side, through the chopper/spreader. Add each of them together to figure total yield loss. Beans lost per square foot behind the separator means nothing without header width.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
