Posted by jdemaris on November 03, 2010 at 05:52:00 from (67.142.130.30):
In Reply to: Re: heaters posted by Stuart on November 02, 2010 at 21:22:08:
I guess you do NOT believe in the scientific law of "Conservation of Energy." Or, the First law of Thermodynamics?
With a non-vented heater, all the "exhaust" is used to heat the room and is not lost via a vent or chimney. Does not matter if it's infrared, or not.
Depending on why someone is using it, you've got things backwards.
First of all - a heater is converting energy, from one state to another. Be it electric or propane, both are almost 100% efficient (if the propane is non-vented and no electric blower involved). If it IS vented,then efficiency goes way down. Note, I'm talking 100% efficiency only within this closed loop of existing fuel into heat, and am not figuring in how much energy is wasted making the electricity or propane.
Second - after that conversion is made, the way the heat travels is a factor - depending if you want an entire area generally warm, or wish to target certain areas. You cannot have a loss if all takes place within the room you are heating.
For somebody with a cold room who does not want to completely heat it up, infrared is more efficient since a few people can get warm next to it, without entire room heating. I.e., you are only using enough fuel to heat the people and nearby objects. Often you can run the heater at a lower setting and use less fuel per hour.
Both styles of heat are equally efficient for heating the entire room. There is no difference. The heat does not magically disappear at a higher rate with either mode of heat transfer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
