Posted by Dell (WA) on November 11, 2010 at 21:50:30 from (207.200.116.74):
In Reply to: 8n won't stay running posted by Wesley B on November 11, 2010 at 19:06:53:
Wesley.......the 3-terminal starter mounted solenoid needs to be mounted so the little middle terminal is facing the engine where it is hard to gitt too. ONLY the heavy copper buss-barr is between the starter motor stud and the solenoid. NO EXTRA WIRES!!! The HEAVY BATTERY cable is connected to the other BIG STUD of the solenoid with yer IGNITION SWITCH wire to the ampmeter.
Make certain yer solenoid wiring is as described, and guess what??? Yer tractor will keep running as long as the weaksister ignition switch is ON.
And yer problem has 'nuttin' to do with the "infamous ballast resistor". Ballast resistors are like litebulbs, they either work or they don't. Since you can gitt the engine to run, guess what??? The ballast resistor is NOT yer problem. .......respectfully, Dell yer self-appointed sparkie-meister
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
