Posted by Kentb of SWMO on November 15, 2010 at 06:41:29 from (71.30.131.57):
In Reply to: Magneto no spark posted by dan w MN on November 14, 2010 at 18:59:32:
On a Magneto,the kill wire terminal is also the insulated terminal of the points. This is also the point where the coils primary wire is connected. The difference in the resistance reading between the point being closed and open, where you read the resistance on the mag coils primary is most of the time around ONE OHM of less. Most ohm meters, especially digital's, can not tell the difference of one ohm and zero ohms. I have a few ohm meters. I recently bought a relatively cheap analog meter from MCM Electronic just for the shop. If it got damaged it would be no great loss. TO MY surprise, I found with it set in the RX1 range I could read the difference between open and closed points in a Magneto. It was a VERY pleasant surprise.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.