Posted by gene bender on November 16, 2010 at 02:46:59 from (67.55.227.196):
In Reply to: Sediment bowl gasket posted by paramedicchuck on November 15, 2010 at 11:04:53:
I wont use cork i get the screen and gaskets which are neoprene rubber from CAR QUEST cleaning up the assy can usually seal just using fingers. Som think a pliers ir the tool and end up warping the base so theres no way it can seal. New gasket and screen is less than 5 bucks. To seal the bulb assy in the tank i like the tube of Teflon on the threads in the tank and the fitting from the carb has done an excellent job for me. Nothing is worse than a gas leak on a new paint job. I have also used nylon thread to make a new seal for the shut=of valve on the sediment assy.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
