Posted by olddog on November 22, 2010 at 13:16:41 from (24.229.174.134):
In Reply to: Shop heat question posted by ks willie on November 22, 2010 at 06:55:12:
If you cut a hole thru the wall between lean-to and shop, into the furnace cold air return, that will be your (only) warmest spot in the shop. If you run a cold pipe to the opposite wall in the shop, THAT spot will be the warmest spot but will help to heat what's in between it and where the heat comes in. Utopia (which never happens), would be a cold air return pipe to each of the far corners of the shop floor, back to the cold plenum, if you got BTU enough. You are moving the cold air with the blower. Because nature abhors a vacuum, heat will flow up (and over) to fill any space in which the cold air has been removed.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
