Posted by westom on November 26, 2010 at 15:00:49 from (4.238.145.143):
In Reply to: Re: Surge Protection posted by Don Hopf on November 26, 2010 at 06:28:54:
As accurately noted, the GFCI is to protect humans. A surge protector is almost defined accurately.
A surge protector earths destructive surges. Surges that are connected to earth outside the building, then, do not go searching for earth destructively via appliances. Then protection already inside all appliances is not overwhelmed.
GFCI is for human safety. Effective surge protection is for transistor safety. The protector is not protection. The protector either connects surges harmlessly to protection. Or it does virtually nothing.
Essential to transistor protection is a 'whole house' protector connected within feet of single point earth ground. Where does massive energy harmlessly dissipate? In the protection - single point earth ground.
Effective protectors are sold by more responsible companies including Leviton, Square D, General Electric, Siemens, ABB, and Intermatic. A Cutler-Hammer solution sells for less than $50 in Lowes and Home Depot.
Why does one 'whole house' protector protect everything? Because it is connected 'less than 10 feet' to single point earth ground. What is the #1 item always inspected or upgraded to protect all appliances? Where is even a direct lightning strike harmlessly absorbed? Lightning is typically 20,000 amps. So one 50,000 amp 'whole house' protector connects even direct lightning strikes harmlessly (and short) to the upgraded single point earth ground - the protection.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
