Posted by JDseller on November 27, 2010 at 18:06:18 from (208.126.196.144):
In Reply to: OT glow plugs posted by steven-id on November 27, 2010 at 12:08:39:
I had Chev 6.2 diesel for years. When they went bad they would mushroom the end making them hard to get out. If your engine has a precombustion chamber ( I think it does) remove the injector. You then can make a little pry bar to push on the bottom of the glow plug. About half of the time you can get them to come out that way. If that does not work. Take a rag and plug the port that goes from the chamber into the cylinder. Then drive the broken glow plug piece into the precombustion chamber. Then you just break it into small enough pieces to take out through the injector hole. I had to do that on my first go round on the 6.2 Chev. after I had already pulled the cylinder head. You still could not get to the bottom of the glow plug. So I had to work it out the injector hole. So after that I just did that while the head was still on the engine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
